Request Broker Log Levels

The Request Broker reports various information and messages to the foreground window, or the log file if selected. The amount of detail that is shown is controlled by the loglevel parameter.

Define the required loglevel on the command line call. For example to get loglevel 7, use:

oplrqb +loglevel 7

or

oplrqb -l 7

Alternatively set the loglevel default in the oplrqb.ini file.

[Request Broker]
CommandLine = +loglevel 7

When a loglevel is specified, the messages from priority 0 up to that level are shown. Thus using +loglevel 5 will produce messages from levels 0, 1, 2, 3, 4 and 5. Specifying +loglevel 9 is the same as +loglevel 7 as levels 8 and 9 are not defined.

Typical loglevels are 7 for troubleshooting, 3,4 or 5 for normal use, and 0 or 1 for a limited report. The if a loglevel is not specified, then a default of 5 is used.

The level of detailed for each log level is as follows:

Table: 1. Log Levels

Level	Category	Comment
0	EMERG	System is unusable
1	ALERT	Action must be taken immediately
2	CRIT	Critical conditions
3	ERR	Error conditions
4	WARNING	Warning conditions
5	NOTICE	Normal but signification condition
6	INFO	Informational
7	DEBUG	Debug-level messages